Everex StepNote VA4300M User Manual download pdf (Page 94)

Notebook User Guide

5. Insert the connector of the memory module into the socket. Make sure

the notch of the memory module fits the nose of the socket.

y Hold the memory module at a 30-degree angle and push its

connector into the memory socket of the notebook.

y Press down on the edge of the memory module until the locking

tabs on both sides is locked.

6. Put the DIMM door back and secure the screw on the DIMM door.

7. Turn the system over.

To remove a memory module, push the locking tabs aside from the memory

module until the module pops up. Then, remove the memory module.

*Everex recommends using only Everex approved upgrades and accessories.

Use of non-approved Everex memory modules are not guaranteed compatible

with the StepNote line of computers and are not covered under the Everex

Standard Warranty Agreement. Visit www.everex.com to view the complete

line of approved accessories.

7.2 Hard Disk Upgrade

Your notebook computer offers one 2.5" format, 9.5mm height hard disk. If

the volume does not fit your need or it become inoperable, you can upgrade it

by replacing with new hard disk. Please do the following steps to change it.

1. Remove the screw and open the cover by lifting its upper side cover.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 137 138

No comments

Everex StepNote VA4300M User Manual Page 94